A Gas Chromatograph Gc Is A Device Used To Separate

A gas chromatograph (GC) is a device used to separate the components of a sample of a gas or liquid mixture and to provide a measure of the amount of each component in the sample. The output from a chromatographic analysis typically takes the form of a series of peaks on a strip-chart recorder. (See the preceding problem). Each peak corresponds to a specific component, and the area under the peak is proportional to the amount of that component in the sample [ni mol) = ki Ai, where Ai is the area of the peak corresponding to the ith species]. The proportionality constants (ki) are determined in separate calibration experiments in which known amounts of the components are injected into the GC sample port and the corresponding peak areas are measured.

(a) Prepare a spreadsheet to calculate the composition of a mixture from a set of peak areas obtained from a chromatograph. The spreadsheet should appear as follows: you may use additional columns to store intermediate quantities in the calculation of the mass and mole fractions. In the actual spreadsheet, the dashes (–) would be replaced by numbers. Test your program on data for five mixtures of methane, ethane, propane, and n-butane. The k values for these species are those given in the above table, and the measured peaks are given below. For example, the area of the methane peaks are given below, for example, the area of the methane peak for the first mixture is 3.6, the area of the ethane peak for the same mixture is 2.8, and so on.

Don't use plagiarized sources. Get Your Custom Essay on
A Gas Chromatograph Gc Is A Device Used To Separate
Just from $13/Page
Order Now

A gas chromatograph (GC) is a device used to separate

(b) Write a computer program (not a spreadsheet) to perform the same task-that is, calculate mole and mass fractions from measured chromatographic peak areas. The program should perform the following steps:

i. Read in N, the number of species to be analyzed:

ii. Read in M1, M2, M3, . . . , MN, the molecular weights of the species:

iii. Read in k1, k2, k3, . . . , kN the calibration constants for the species;

iv. Read in Nd, the number of chromatographic analyses performed;

v. For the first analysis, read in the measured peak areas A1, A2, A3, . . . , AN;

vi. Calculate and print out the sample number, the mole fractions of each species in the sample, and the mass fractions of each species in the sample;

vii. Repeat steps v and vi for each of the remaining analyses. Test your program on the five-sample data set given in part (a).

NOTE:
We have worked on a similar assignment and our student scored better and met their deadline. All our tasks are done from scratch, well researched and 100% unique, so entrust us with your assignment and I guarantee you will like our services and even engage us for your future tasks. Click below button to submit your specifications and get order quote

Get started